FORUM DU LOGICIEL PRISM

Hello,
I have an Optec Leo focuser with an external temperature probe.
If I run the Optec wizard for determining the temperature coefficient, I get a value of -1454 steps/degree Celsius.
In Prism.v.11,focuser 1, do I input the -1454 or +1454 value?

Thank you, have a nice day

Also, if I try to enter -1454 into Focuser 1, I get an error: the maximum value is -1000 steps/degree

Hello,

For the Optec TCF-S, I can use the focuser panel (Ascom Driver)


Marc

Yes, but I would like Prism to handle the temperature compensation, and I cannot enter a value bigger than 1000 steps.
The optec Leo focuser has 80 nanometers per step, resolution, so I need much bigger steps

Hello
I have increased the max figure from +/- 1000 to +/- 10 0000
V11.4.14 to come.

Thank you very much Cyril!